Effect of body position during the Wingate Test

Authors

  • Jakub Kadlec Department of Sports Studies, Faculty of Education, University of South Bohemia, CZECH REPUBLIC Author
  • David Marko Sport Research Center, Faculty of Physical Education and Sport, Charles University, Prague, CZECH REPUBLIC Author
  • Joseph D Vondrasek Department of Health Sciences and Kinesiology, Georgia Southern University Armstrong Campus, Savannah, GA, USA Author
  • Petr Bahenský Department of Sports Studies, Faculty of Education, University of South Bohemia, CZECH REPUBLIC Author

DOI:

https://doi.org/10.7752/jpes.2022.03086

Keywords:

anaerobic test, cycling position, performance, mountain bikers

Abstract

The 30-second Wingate anaerobic test (30-WAT) is a well-established assessment of peak anaerobic power output (absolute and relative) and represents the physiological demands of a short sprints that competitive cyclists perform while they are starting a race or attacking at a finish. During these short sprints it is common for athletes to raise out of the saddle and assume a standing position. However, the 30-WAT is usually completed in a seated position which is dissimilar to the standing sprints observed in cyclists. The change in anaerobic power output during different riding positions is important for athletes and coaches to consider when testing maximum power output. Purpose: The purpose of this investigation was to compare anaerobic power output in a group of competitive cyclists while they completed multiple 30-WATs in different riding positions. Methods: Thirteen competitive male mountain bikers (20.5 ± 2.5 years) performed three 30-WATs on non-consecutive days over the course of one week. Each participant completed 1 only sitting (SIT), 1 only standing (STD), and 1 combination (COMB) test in which they started in a seated position and transitioned to a standing position at the halfway mark (~15s). The testing order was randomized for all participants. Each 30-WAT was completed on a LODE Excalibur Sport (Lode B.V., Groningen, The Netherlands) ergometer. Power was monitored using a commercially available software/hardware package (Lode B.V., Groningen, The Netherlands). Data were analyzed using a one-way repeated measures analysis of variance (=0.05). Results: Absolute power output during SIT (724±82 W) was significantly lower (p < 0.01) than outputs during STD (744±81 W) and COMB (746±81 W) protocols. Furthermore, relative power was significantly lower in SIT (9.5±0.7 W∙kg-1) compared to STD (9.8±0.7 W∙kg-1) and COMB (9.8±0.6 W∙kg-1) protocol. Amongst all measured variables, no statistical differences were detected between the STD and COMB protocols. Conclusion: Greater power outputs were achieved when cyclists utilized a standing position or changed to a standing position halfway through the 30second test. It may be more appropriate to assess a competitive cyclist’s performance during a 30-WAT test in a standing or partially standing position to accurately quantify peak anaerobic output.

Downloads

Published

2022-03-31

How to Cite

Effect of body position during the Wingate Test. (2022). Journal of Physical Education and Sport, 22(3), 690-695. https://doi.org/10.7752/jpes.2022.03086